packet tracer 8.3.1.2 ccna skills integration challenge

O Set the port to send a message if there is a security violation. O Configure the learned MAC addresses to be added to the configuration. O Allow two MAC addresses to be learned on the port. Use the following policy to establish port security on the B1-S2 access ports:.O Disable all unused ports and assign the BlackHole VLAN. O Assign VLANs to the appropriate access ports. O Set trunking mode to on for F0/1 - F0/4. O Configure the VLAN 99 interface and default gateway. O Create and name the VLANs listed in the VLAN Configuration and Port Mappings table on B1-S2 only. If you would prefer to view console messages, enter the global configuration command logging console. Note: Logging to the console is turned off on B1-S2 so that the Native VLAN mismatch messages will not interrupt your configurations. O Disable EIGRP updates on appropriate interfaces. Configure and optimize HQ and B1 with EIGRP routing.Use the next-hop IP address as an argument. Configure B1 with a default route to HQ.Configure HQ with a static route to the NewB LAN.O Using the addressing table for branch routers, configure and activate the LAN interface for inter-VLAN routing. O The connections to the Internet and HQ-DataCenter are outside XYZ Corporation. O XYZ Corporation owns the 209.165.200.240/29 address space. O Allow all addresses for the 10.0.0.0/8 address space to be translated using a standard access list named NAT. O Advertise the 192.0.2.0/24 network to the Internet. O The IP address for the BGP router in the Internet cloud is 209.165.201.2. Configure eBGP between HQ and the Internet.However, it must be configured before the link will come up between HQ and NewB. Note: The ppp pap sent-username is not graded by Packet Tracer. O Create a user NewB with the password of cisco.

Configure the WAN link from HQ to NewB using PPP encapsulation and PAP authentication.

O Create a user ISP with the password of cisco.

Configure the WAN link from HQ to the Internet using PPP encapsulation and CHAP authentication.

The user EXEC password is cisco and the privileged EXEC password is class. Note: Only HQ, B1, B1-S2, and the PCs are accessible. Security configurations include SSH, port security, switch security, and ACLs. Other technologies include NAT, DHCP, static and default routing, EIGRP for IPv4, inter-VLAN routing, and VLAN configurations. In this comprehensive CCNA skills activity, the XYZ Corporation uses a combination of eBGP and PPP for WAN connections.

Packet tracer 8.3.1.2 ccna skills integration challenge